LEXMARK OPTRA COLOR 1200 PS DRIVER

Remove the press roller. Remove the registration roll, 4 black screws. When you reinstall the fuser, be careful not to damage the fuser exit sensor actuator. Before adjusting the margins, be sure the printer is set to the graphic print mode in the Print Quality Menu. See questions and answers.

Uploader: Tugis
Date Added: 19 August 2007
File Size: 62.35 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 98964
Price: Free* [*Free Regsitration Required]

When you do replace them, replace all three—cyan, magenta, and yellow—at the same time.

The X after the card indicates which one has the problem. Remove the affected print unit and gently shake it back-and-forth to distribute the toner evenly.

Lexmark Optra Color 1200 – printer – color – LED Series

Forms and bar code card release notes october 4 pages. Place it in position by holding only the edges of the board. Parts peculiar to one or the other of the assemblies are listed separately and identified by description. Use the error code tables, symptom table, service checks and the diagnostic aids chapter to determine the symptom and repair the failure.

  KONICA BIZHUB C452 DRIVER DOWNLOAD

Tablets by David Carnoy 7 days ago. Don’t show me this message again. Remove the drive board from the bracket, 4 screws.

Page You can also note the position of the fuser on the embossed scale on the bottom of the fuser frame. Press to print the jobs.

Remove the power supply board. Repair Information Precautions for Disassembly and Cleaning Observe the following precautions whenever you service the leexmark Common parts are shown by one index number.

OHP Sensor Removal 1. Remove the registration roll, 4 black screws. Page 51 Message Engine Error 1. Feeder Parts Catalog Pageregistration viewing and resetting the drum registration roller removal counters registration sensor removal viewing the error log removal procedures viewing the permanent page count remove paper sensor service check RIP controller card layout RIP controller card removal Page Assembly 5: Remove the rear cover and the right side cover.

Lexmark Optra Color N – printer – color – LED Overview – CNET

optrra Run tests in the service mode. Optional Feeder Base Parts Catalog Cleaning Assembly Cleaning Assembly The cleaning blade scrapes off the remaining toner on the photoconductor drum after the toner image has been transferred to the paper.

  CREATIVE N400 MAC DRIVER DOWNLOAD

The fuser temperature is set at 20 degrees higher than normal printing. Remove the thermistor harness connector. Toner scatter on front Check the following: Service Checks Service Checks Fuser Service Check When you work on the fuser be sure to reposition it to the original mounting position.

LEXMARK OPTRA COLOR SERVICE MANUAL Pdf Download.

Image Unavailable Image not available for Color: It may be a little to the right. Remove the paper full sensor from the exit cover. Disconnect the BUD motor connector and lecmark the 2 mounting screws.

Have one to sell? Before you replace an entire assembly, determine if just the defective part is available in the parts catalog.